by Matt
16. April 2010 07:38
For models 1561, 1569, 1580, 1584, 1590, 1590A, E117A, E130A, E130B, E136G, E130J
Unplug the canister and remove the low voltage wiring.
Using both handles, slide the canister straight up off the mounting bracket, and place the canister on the ground.
Remove 3 small screws from the top of the of the canister, and then remove the top cover. You should now be able to see the motor.
Now remove the 3 bolts on the motor, and disconnect the motor leads. After this is done you will now be able to take out the motor. Also, remove the coupling on the horn of the old motor and place on the new motor.
Clean the screen below the motor if necessary.
When putting in the new central vacuum motor make sure there is a gasket between the motor and the canister create a tight seal, then tighten the bolts and reconnect the motor leads.
Put the top cover back on and remount on the wall.
Subscribe